grbl is stepper motor controller firmware for three-axis cnc machines, intended to run on Arduinos with a motor driver add-on board. Engineer in Wonderland cnc-related blogs are indexed here It is the ...

[Dan] salvaged some parts from an old printer a while back and finally found some time to play with them. One of the things he was most interested in is the geared stepper motor seen above. He was ...

TRINAMIC Motion Control's new TMC2660 stepper motor driver IC supports motor drive currents up to 4A. The new IC integrates both a pre-driver for real-time calculation of motor coil current values, ...

Designed for medical devices, scientific and optical instruments, embedded automation applications, and other small-footprint devices needing dual-axis motion control, this system is designed to work ...

Mikroe has added a smart 85V 10A stepper motor driver to its range of interchangeable ‘Click’ boards. Called Power Step 2 Click, the board “is based on the powerSTEP01, a 1/128 microstepping ...

Toshiba Electronics Europe has introduced the TB67S559FTG 50V/3.0A stepper motor driver IC that supports constant current control with built-in current detection. 50V/3.0A constant current stepper ...

For his entry into the 2019 Hackaday Prize, [Tobius Daichi] is working on adding some motion control capabilities to everyone’s favorite Linux SBC. His 3+Pi board attaches to the Raspberry Pi’s GPIO ...

Oriental Motor is pleased to announce the arrival of the EtherNet/IP communication protocol to the αSTEP AZ Series AC Input stepper motor drivers. This new EtherNet ...