Sep 23, 2019 · When performing precision shaft alignment on horizontal rotating machinery, the Z axis refers to the rotational axis or rotational centerlines. The Y axis refers to vertical position …

Jan 23, 2024 · And, seemingly out of nowhere Z axis homing fails constantly. I did print the top mount with the brackets and put that top and the brackets on the Z axis… so I took that all off. …

Dec 9, 2023 · The z-offset is the difference between the tip of the nozzle and the zero point of the z-axis sensor. The sensor is triggered when the nozzle touches the surface.

May 10, 2022 · When you perform the z calibration, the instructions say to take off the sheet. So I did, the test continued and failed immediately. u/bushpylot got it, and I needed to raise the z …

Jul 3, 2020 · On my 5 plus, the in-print z-axis compensation step size is 0.1mm, which is the same as the z-offset step size on the leveling page. Is there a finer resolution z-offset setting …

Jan 31, 2012 · If x and y are horizontal, z is vertical; if x and z are horizontal, y is vertical. The words horizontal and vertical are generally used in a planar (2-dimensional) sense, not spatial …

Oct 20, 2023 · Yes. In my case, debris got stuck near the back x axis rod + work gear, so I had to gently remove the back panel (there’s a couple of snag points you have to finesse), reset the …

Jan 23, 2024 · We were getting a lot of z axis failures after the previous firmware update. Updated with latest last night and knock on wood working ok.

Jan 15, 2024 · Assuming you were trying to add thickness under the cityscape model you have a few options. You could add a primitive cube the size of your model. Alternative would be to …

Aug 15, 2022 · In mathematics, the Z axis is normally defined as up. X and Y are often used in 2D problems, and a lot of 2D problems are parallel to the surface of the earth, so it makes sense …